Sponsored Links



Vehicle > Off Road Vehicle

1986 Honda ATC250R - $5600

  • Publish Date: 09-10-2019 22:35:26 |
  • Contact: Mike M (see all posting) |
  • Location: Tucson 85637 |
  • Place: Sonoita,AZ |
  • 88 times displayed |
1986 Honda ATC250R1986 Honda ATC250R
1986 Honda ATC 250R three-wheeler. 250cc two stroke, 6 speed, water cooled engine. 34mm Kiehin oval slide Carburetor with 6 petal reeds. This is a factory Honda ATC which was the last production year. Full Pro-Link suspension front & rear with 9.8 inches of travel on both. Front Air Forks. Rear shock adjustable load spring and rebound damping adjuster screw. Has the easy quick turn knob from hard to soft preload damping reservoir. Front & rear dual piston hydraulic disc brakes. I am the original owner who bought this from Honda dealership in 1986 new. Truly low hours of use overall. Estimated 60-70 hours total. Just did the first top end rebuild. Bored, Piston, rings, etc... 66.50 bore. Still has the original tires which have very good tread on them which is indicator of low hours overall. Original seat with no tears, cuts or holes. Only used for the first couple years until about 1989. Equipped with a stainless steel Pro Circuit performance exhaust pipe & Aluminum silencer. I have original complete exhaust for it. Original tool box with tool kit, extra jets & original owner’s manual. K&N air filter. Both chain sliders replaced with high quality polyurethane sliders. Gas tank has cosmetic pitting as they all do after 33 years. No leaks, Still fully functional. New Ceet Racing vinyl gas tank cover that looks great. New rear fenders. Some small dents on the rim lips as is expected & gold coating on inside of rear rims is wearing off from sand wear as expected. About 90% original. Look at photos section for a list of newer parts. These ATC’s have the low-profile 4-ply rear tires which make the handling & turning exceptional. Front tire is the thinner width & taller profile size which also makes turning & handling much better. Factory Aluminum wheels front & rear. Must come see if really interested in purchasing. Since I am the original owner who purchased this ATC in 1986 from the dealership, I know the true limited number of hours on it. It has never been wrecked, rolled down any hill or any kind of damage to it. Normal wear from the first couple years of use. Stored in a garage since about 1989 and only started up & rode for a short time every so often to keep lubrications up. Other ATC’s you may find out there could have had many problems, repairs or any unknown number of hours of use on them. I’ve done the research and I know the value of these ATC’s. This is above exceptional condition and extremely clean. I am very meticulous with all my vehicles. Just went through it to check & replace any parts that I felt were best to replace. New Tusk Products Hour/Tach Meter. New Tusk Radiator Cap w/temp gauge. This is a must see to appreciate Vintage/Classic ATC. Honda ruled the dirt with these three-wheelers. If you want a 4-wheel ATV killer then this is it. These ATC’s are top of the line, extremely quick & fast. A true monster. Serious buyers only please. I will not negotiate a price online. You must come look at it to discuss. If this is too much for you then please be respectful and move on. I’ve owned this for 33 years. I’m in no hurry to sell. See Craigslist for more. Thanks, and happy hunting.
1986 Honda ATC Parts list:
First time bore to 66.50mm with new Piston, Rings,
wrist pin, needle bearing, cir-clips, gaskets. $250
New Maier Rear Fenders $213
New Tusk Products
Hour/Tach meter $28
New Tusk radiator cap
w/temp gauge $26
New Light Control/
Kill switch $60
New Ceet Racing gas
tank cover $68
New DG Grab bar $82
New Fork boots $18
New Fork seals $15
New skid plate slider $40
New front swing-arm
chain slider $35
New axle bearings & seals $10
New Spider grips $15
Petcock, seals & Carburetor float bowl gasket $20
New Chain $45
New Boss Racing billet aluminum high temp
double o-ring exhaust flange $40
New Sixity Powersports
Semi-metallic organic
brake pads front & rear $11
New brake cylinder diaphragm seals & plate x 2 $20
New fuel line & filter, exhaust seal, transmission oil,
brake fluid, coolant, fork oil, taillight lens & gasket,
metal valve stems & misc.. $50
Total = $1,046
Equipped with a Pro Circuit high performance
stainless steel exhaust pipe
w/Aluminum Silencer $250
K&N Air Filter $35
Total Value = 285
Sell Includes rear 36 tooth sprocket, (higher gearing)
& new 13 tooth front sprocket, (higher gearing) $40
Total parts = Approx. $1,371

I have the complete original stock exhaust, air box cover,
original toolbox w/original tools, assortment of carburetor jets
& Owners manual. A few other small items I will be throwing
in with sale.

Tags: atv | honda

Sponsored Links